Custom Search
|
|
|
|
||
|
||
 TM 9-2330-394-13&P
BRAKE SYSTEM TROUBLESHOOTING - Continued
0037 00
BRAKE SYSTEM - Continued
Table 1. Brake System Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
Loosen connector retaining
4.
Check to see if continuity is
12. ANTI-LOCK BRAKING
clip on connector YE2.
present across right rear ABS
SYSTEM (ABS) DIAGNOSTIC
control sensor harness
TOOL BLINKS SIX TIMES IN
connector with jumper wire
SERIES: RIGHT REAR ABS
across connector YE2.
WHEEL SPEED SENSOR
FAULT (MTVT) - CONTINUED
2.
Disconnect connector YE2
from ABS ECU.
3.
Install jumper wire across
connector YE2.
4.
Connect positive (+) probe
of digital multimeter to one
pin of ABS control sensor
harness connector.
5.
Connect negative (-) probe
of digital multimeter to other
pin of ABS control sensor
harness connector and note
reading on digital
multimeter.
6.
If continuity is not present,
replace ABS control sensor
harness (WP 0069 00).
7.
If continuity is present,
replace ABS ECU (WP 0065
0037 00-55
|
||
|
||
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
