Custom Search
|
|
|
||
 TM 9-2330-394-13&P
LANDING GEAR AND WINCH REPLACEMENT/REPAIR - Continued
0104 00
CLEANING/INSPECTION
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective
goggles and gloves; use only in well-ventilated area; avoid contact with
skin, eyes, and clothes, and do not breath vapors. Keep away from heat or
flame. Never smoke when using Dry Cleaning Solvent; the flashpoint for
Type I Dry Cleaning Solvent is 100 F (38 C) and for Type II is 138 F (50
C). Failure to comply may result in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent, immediately
get fresh air and medical help. If solvent contacts skin or clothes, flush with
cold water. If Dry Cleaning Solvent contacts eyes, immediately flush eyes
with water and get medical attention. Failure to comply may result in
serious injury or death to personnel.
Compressed air used for cleaning purposes will not exceed 30 psi (207
kPa). Use only with effective chip guarding and personal protective
equipment (goggles/shield, gloves, etc). Failure to comply may result in
injury to personnel.
NOTE
Replace any part that fails visual inspection.
1.
Clean all metal parts with Dry Cleaning Solvent.
2.
Dry metal parts with compressed air.
3.
Inspect landing gear (11) and welds around landing gear for cracks and corrosion.
0104 00-11
|
||
|
||
