Custom Search
|
|
|
||
 TM 9-2330-394-13&P
AXLE BOGIE (MTVT) REPAIR - Continued
0121 00
ASSEMBLY - Continued
6.
Press two bearing races (14) in housing (7).
CAUTION
Use care when installing housing. Seals are easily damaged. Failure to comply may
result in damage to equipment.
7.
Install housing (7) on shaft (13).
8.
Position cone (12) in housing (7).
9.
Position mounting plate (11) on shaft (13) with three screws (10).
NOTE
Axle bogie components have very close tolerances. It may be necessary to seat housing
on shaft with a deadblow hammer prior to tightening screws.
10. Tighten three screws (10) to 150 lb-ft (203 Nm).
0121 00-10
|
||
|
||
