TM 9-2330-398-10
3-6. BATTERIES, TERMINALS, AND CABLES SERVICE (continued).
a. Remove four wingnuts (1) and washers (2) securing battery cover (3) to battery hold-down bracket (4). Remove
battery cover (3) from hold-down bracket (4).
b. Inspect battery area for excessive dirt and corrosion. Clean battery area with mixture of baking soda and water,
then flush battery area with clean water.
c. Check four cables (5) for frayed insulation. If insulation is worn or frayed, notify Unit maintenance.
d. Check terminals (7) for looseness. If loose, notify Unit maintenance.
e. Remove 12 vent fill caps (6) and check electrolyte level. Electrolyte level must be just below ring at bottom of
each cell opening. If electrolyte level is low, notify Unit maintenance. Install 12 vent fill caps (6).
f. Install battery cover (3) on hold-down bracket (4) with four wingnuts (1) and washers (2).
FOLLOW-ON MAINTENANCE:
None
3-25
