TM 9-2330-398-10
3-11. FUEL-DISPENSING NOZZLE MAINTENANCE.
This Task Covers:
a. Removal
b. Service
c. Installation
Initial Setup:
Materials/Parts:
Equipment Conditions:
Drycleaning solvent (Item 6, Appendix D)
All fuel-handling valves closed (para 2-16).
Rag (Item 15, Appendix D)
a. REMOVAL
1. Unscrew fuel-dispensing nozzle (2) from hose (1).
2. Using suitable container, drain fuel from nozzle (2) and hose (1).
NOTE
Cover end of hose with rag to keep out dirt and debris.
b. SERVICE
NOTE
Screen in fuel-dispensing nozzle must be cleaned
periodically and whenever flow through nozzle is
restricted.
1. Unscrew spout (4) from nozzle (2).
2. Remove screen (3) from inside of spout (4).
WARNING
Drycleaning solvent P-D-680 is toxic and flammable.
Always wear protective goggles and gloves, and
use only in a well-ventilated area. Avoid contact
with skin, eyes, and clothes, and DO NOT breathe
vapors. DO NOT use near open flames or excessive
heat.
3. Clean screen (3) with drycleaning solvent and rag. Use compressed
air to dry screen and remove any excess material.
4. Install screen (3) in spout (4).
5. Install spout (4) on nozzle (2).
c. INSTALLATION
Install nozzle (2) on hose (1).
FOLLOW-ON MAINTENANCE:
None
3-31/(3-32 blank)
