TM 9-2350-222-10-2
OPERATE UNDER UNUSUAL CONDITIONS (PERFORM DEEP WATER FORDING) - Continued
7.
Go to inboard end of exhaust tube (G). Using 7/16
inch socket, ratchet, and 7/16 inch open end wrench,
remove two nuts, two screws, and four washers (H).
These hold clamp (J) and exhaust tube (G) to exhaust
elbow (K).
8.
Pull exhaust tube (G) from elbow (K). Put end of tube
on fender.
9.
Slide exhaust tube (G) back about 2 inches.
10.
Place two nuts, two screws, and four washers (H) in
clamp (J) and tighten.
TA252888
2-688.14
Change 1