TM 9-2350-222-10-2
OPERATE UNDER UNUSUAL CONDITIONS (PERFORM DEEP WATER FORDING)- Continued
WARNING
Do not apply turret power or operate turret controls until all personnel are in safe positions and prepared for turret
or gun movement.
Do not operate turret in power or manual mode until all personnel are in proper position, turret ring has been
cleared, and shell ejection plate and all platform guards are in place.
Do not reach in or attempt to enter or exit driver's compartment until turret power switch is off and turret traverse
lock is in locked position.
Crew members out of station are in extreme danger when turret power is on. Commanders must shut down turret
power before allowing crew members to leave their stations.
3.
Lower driver's seat as far as possible (page 2-167).
4.
Move driver's seat to rear as far as possible (page 2-168).
5.
Disconnect driver's communications cord connector (C) from cord
connector (D).
6.
Driver, lean back toward turret. Grab overhead equipment. Pull
yourself into turret compartment.
Change 4 2-668.38
