TM 9-2350-230-12
TABLE 2-3. STARTING! DRIVING, AND STOPPING VEHICLE - Continued
STEP
PROCEDURE
REFERENCE
DRIVING VEHICLE ON LAND - Continued
27
Perform during-operation preventive-maintenance checks and
services if tactical situation permits (table 4-1, steps 64 through 67).
NOTE In case of emergency, driver can escape by his escape
hatch or through the turret by pulling pin safety clip chains securipg
2/27
vertical ammo rack and screens to turret ring.
STOPPING VEHICLE AND ENGINE
28
Release accelerator pedal, depress brake pedal, and stop vehicle
29
With brake pedal depressed, position transmission shift lever in N
(neutral) position, pull out and up on parking BRAKE LOCK handle
to lock brake.
30
Turn SPEED/RPM indicator switch to RPM position
31
Set hand throttle control knob to run engine at 1000 - 1300 rpm on
32
Push hand throttle control knob in to return engine to normal
idle speed.
33
Turn radio and all accessories off
34
Pull out on engine FUEL SHUT-OFF control handle to stop engine
CAUTION: Do not apply excessive pull on handle when stopping
engine.
NOTE If FUEL SHUT-OFF valve does not operate properly,
open engine exhaust grille and disconnect fuel line at primary fuel
filter.
35
Turn vehicle MASTER SWITCH off
36
Perform after-operation preventive-maintenance checks and services
2-8.2