TM 9-2350-230-12, C6
STEP
PROCEDURE
STEP
PROCEDURE
1.
MAKE CERTAIN SAFETY IS
IN
SAFE
"S"
1.
INSERT EXTRACTOR THRCUGH RUPTURED
POSITION.
CARTRIDGE INTO BARREL UNTIL COLLET
ENGAGES FORWARD END OF CASE.
2.
POSITION TOOL ON CARTRIDGE CASE HEAD
AND PRESS FORWARD TO REMOVE.
2
INSERT ASSEMBLED CLEANING ROD THROUGH
MUZZLE END OF BARREL AND DRIVE
EXTRACTOR AND RUPTURED CARTRIDGE
:
WARNING
INSPECT CHAMBER TO
CASE FROM CHAMBER.
INSURE PROJECTILE WAS NOT SEPARATED
FROM CASE DURING REMOVAL.
Figure 3-6. Removing live round of, ruptured cartridge case from 7.62 mm machine gun
INSTALLATION
REMOVAL
1. DISCONNECT MACHINE GUN ELECTRICAL LEAD.
3. MATCH KEYS ON GUN WITH KEYWAYS IN MOUNT
2. REMOVE 2 SCREWS, MACHINE GUN MOUNT CAP,
AND REVERSE REMOVAL PROCEDLIRE
AND LIFT MACHING GUN OFF MOUNT.
SPENT BRASS EJECTION CHUTE EXTENSION
INSTALL ON MACHINE GUN COVER AS SHOWN IN
ILLUSTRATION, AND TIGHTEN TWO SCREWS.
LOOSEN SCREWS TO REMOVE EXTENSION.
WE 120741
Figure 3-7. Removal/installation - 7.62 mm machine gun
3-13
