C11 , TM 9-2350-230-12
ADJUSTMENT (REFER TO FIG. 9-119.3)
PRELIMINARY STEPS (REFER TO FIG. 9-119.3 AND 9-119.4)
1.
LOOSEN LOCKNUT (ITEM 34) AND ADJUST SETSCREW SO
THAT EYEBOLT ASSEMBLY (ITEMS 27 THROUGH 32) IS 90'
A.
RELEASE LATCHES TO PERMIT SURFBOARD EXTENSION
TO
FOLD
DOWN
BEFORE
REMOVING
LATCH
TO HULL SURFACE. THEN BACK SETSCREW OUT TWO
COMPONENTS.
MORE TURNS, AND TIGHTEN LOCKNUT.
2.
LOOSEN LOCKNUTS (ITEMS 28 AND 29) AND ADJUST
LENGTH OF EYEBOLT ASSEMBLY BY TURNING BARREL
B.
BLOCK SURFBOARD SECURELY IN UPRIGHT POSITION
UNTIL UNDER SURFACE OF UPPER SUPPORT (ITEM 22)
BEFORE
REMOVING
SUPPORT
BRACKETS
OR
JUST TOUCHES MACHINED SURFACE OF LOWER SUPPORT
ASSOCIATED HARDWARE.
(ITEM 44). TIGHTEN LOCKNUTS.
3. SURFBOARD RELEASE BRACKET MAY BE ADJUSTED BY
C.
ITEMS 99 THROUGH 116.
REMOVE SCREWS AND
LOOSENING MOUNTING SCREWS (ITEM 54) AND
RETAINING STRIPS AS NECESSARY TO FOLD BACK FRONT
REPOSITIONING BRACKET TO RETAIN RELEASE HANDLE
SECTION OF FLOTATION BARRIER TO GAIN ACCESS TO
(ITEM 38) IN LOCKED POSITION.
ITEMS 99 THROUGH 116. (SEE PHOTO ABOVE.
4. ADJUST SLACK IN WIRE ROPE (ITEM 6) BY MEANS OF
LOCKNUTS (ITEM 5) AT THE LATCH, SO THAT UPPER
INSTALLATION NOTE CLEAN MOUNTING SURFACE ON
SURFBOARD RELEASES SIMULTANEOUSLY WITH INITIAL
SURFBOARD, AND APPLY SEALING TAPE FSN 8030-262-
RELEASE OF MAIN SURFBOARD. UPPER SURFBOARD
9019 ALONG BEAD OF FLOTATION BARRIER BETWEEN
MUST BE RELEASED BEFORE MAIN SURFBOARD
BARRIER AND SURFBOARD.
STARTSTO FALL.
DISASSEMBLY/REPAIR/ASSEMBLY
TA0073361
REPLACE UNSERVICEABLE COMPONENTS AS REQUIRED.
Figure 9-119.2 Disassembly/repair/assembly - surfboard and barriers
(effective vehicle serial no. 70) (1 of 3).
9-126.2
