TM 9-2590-209-14&P
g. Hydraulic Oil Data:
1-8. Tabulated Data..
Hydraulic system
a. General.
The following data is provided for
capacity ..........25 gallons
operating and servicing the M9 bulldozer.
Reservoir capacity .. 11.5 gallons
b. Identification Plate (Fig 1-2).
The
identification plate for the M9 bulldozer is located on the
Type of oil .......OE/HDO-10
top center of the blade assembly and is used for
lubricating
identification and descriptive information.
oil internal
c. Angle
of
Blade
Assembly
Cutting
Edge
engine
(Horizontal):
h. Weight:
Float position ....... 60 degrees
Mount assembly ..... 122 pounds
Lowest position ..... 66 degrees
Headlamp adapters..
8 pounds
d. Relation of Blade Assembly Cutting Edge to
Ground:
Headlamp guards and
support.......... 8 pounds
Lowest position ..... 10 inches
below
Front mounting
brackets and blade
Highest position .... 30 inches
assembly ......... 5,995 pounds
above
Hydraulic cylinders,
Carrying position ... 29 inches
piping, reservoir,
above
and guards .......2,584 pounds
e. Rate of Lift:
Control assembly ... 160 pounds
Tank main engine at
Fixture and
1500 rpm .........4.00 inches
templates ........ ..11 pounds
per second
Total weight
-
Tank main engine at
(less oil) .........8,888 pounds
2400 rpm ........5.50 inches
per second
1-9. Special Tools and Equipment.
Special tools
and equipment designed for direct support and general
f. ,Maximum Forward Speed of Tank with M9
support repair and general use with this equipment are
Bulldozer Kit Installed:
listed in table 1-1 and illustrated in figure 1-3. Table 1-1
and figure 1-3 contain item name and item sequence
Cutting edge to ground
number and are used for identification throughout this
Engine at 1500 rpm and low-
manual. Table 1-1 also contains references to figures
range .............3 miles per
and paragraphs in the manual which describe the use of
hour
the tool. Special tools for direct support and general
support maintenance are listed in Appendix E, which is
Cutting edge
the authority for requisitioning replacements.
raised ........;....15 miles
per hour
1-10. Spares and Repair Parts. Spares and repair
parts are listed and illustrated in Appendix E of this
manual.
1-2
