TM 9-2590-209-14&P
Figure 10-10. Removal or installation of blade assembly (sheet 2 of 2)
(2) Remove screw, lockwasher, and lock
(2) Inspect all components for cracks or
securing pin. Remove pin securing ram assembly to
damage.
pushbeam (view A).
(3) Inspect machined surfaces for pitting
(3) Remove cotter pin, nut, and pin
or wear.
securing pushbeam to mounting bracket (view B).
(4) Inspect remaining hardware for wear,
(4) Install lifting device to pushbeam.
damaged threads, and general serviceability. Replace
components, as required.
(5) Remove two cotter pins, nuts, and pins
securing pushbeam to blade assembly, and remove
d.
Installation (Fig 10-12).
pushbeam (view C).
NOTE
c.
Cleaning and inspection.
Procedures for both left and right sides
(1) Clean all parts, including ho mating
are the same.
surfaces, using drycleaning solvent.
(1) Install lifting device to pushbeam.
10-21
