TM 9-3445-106-14&P
DISAPPEARING FRONT GAUGING STOPS:
FIGURE 11
INDEX TO DRAWING:
A - Socket Set Screws
B - Pivot Pin
C - Gauge Holder
D - Disappearing Stop
D1 - Trim-cut Stop Surface
D2 - Finish-cut Stop Surface
E - Brass Plug
GAUGE ADJUSTMENT:
The Disappearing Front Gauge Stops are used in lieu of a front gauge bar. The stops have two gauge
surfaces, D1 and D2. D1 is used for trimming or squaring of sheets. Surface D2 is used for precise finish
cuts. Distance between D1 and D2 is 1/4".
To set gauge, loosen socket set screws (A) and slide gauge in tee slot to desired position. Surface D1 will be
1/4" further from blade than desired width of finish cut. Tighten Screws (A)
19