SAFETY PRECAUTIONS
WARNING: Each every one of the following items must be observed at all times for safe operation of this machine.
1 - Study this manual before attempting to operate this Shear.
2 - All guards should be secured in place before the machine is put in operation.
3 - Never place fingers under or behind the finger guard.
4 - Be sure Shear table is clear of tools, pieces of material, etc., before actuating Shear.
5 - Check behind Shear before making a cut to be sure no one is removing material or is under the back gauge.
6 - Never shear material between holddowns. Be sure to use at least one holddown.
7 - When shearing narrow strips under one holddown, the holddown should be adjusted to the "far away" position.
Place hands on top of material to prevent fingers in case material tips up during shearing cycle.
8 - When feeding material into the shear, place hands on top of the material at the position of the hand slots.
9 - Never operate the machine buy tying down the foot switch.
10 - Always be aware of the location of the foot switch so that it is not accidentally tripped.
11 - Always turn the clutch selector switch to "OFF" when leaving the operator's station or when material is being
removed from behind or in front of the Shear.
12 - Be sure the main drive motor is "OFF" and the flywheel has stopped before making adjustments or performing
maintenance of any kind.
13 - Never shear material beyond the rated capacity as shown on the capacity plate affixed to the front of the machine.
14 - Never shear material with the clutch selector switch in the "JOG" position.
15 - Be alert for loose, worn or broken parts. Report these items and any unusual noise or action of the machine to your
supervisor.
16 - Keep machine properly maintained. Perform all operator's maintenance as suggested in this manual. All other
maintenance should be performed by authorized personnel only.
17 - Keep the machine clean.
18 - In order to clearly show details of this machine, some covers, shields, doors or guards have either been removed or
shown in an "open" position. Be sure all such protective devices are properly installed before operating this equipment.