TM 9-4120-371-14
Disconnect wiring harness connector (P6) from (J6) on solenoid valve (L2) or connector (PS) from
(3)
(4) Remove nut that attaches coil to valve body.
Remove coil assembly and data plate.
(5)
(6) Remove two screws that attach tube and plunger assembly to valve body. Remove tube and
plunger assembly, and all other removable internal components from valve body.
(7) Check valve body for visible damage. Normally valve body replacement is unnecessary. If valve
body is in good condition, skip steps (8) through (10).
(8) Using screwdriver, remove two screws and lock washers that attach base of valve body to casing
side panel.
Purge the system with nitrogen and debraze the tube connections. (See para 5-7 and 5-8.)
(9)
(10) Remove the valve body.
5-33