ARMY TM 9-4120-380-14
NAVY EE-000-BA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-21
REASSEMBLY
NOTE
When replacement of the motor is necessary perform the following. Install insulator
bushing (11) cut wire leads to 5 inches strip and dead end wires together for 208 Vac 3-
phase operation; and apply corrosion inhibiting compound to both shafts.
a. Coat the bearing cavity of end caps (2) and (9) with grease.
b. Install bearings (5) and (10) onto shaft (4).
c. Insert wavy spring washer (13) and two spacer washers (14)
Damage to rotor could occur if rotor is dropped
d. Carefully insert rotor (6) into motor frame (3)
e. Carefully work end caps (2) and (9) onto shaft ends keeping the match-marks in alignment.
f. Install four through bolts ( 1 ) through end caps (2) and (9). Install four lockwashers (7) and end cap nuts (8) and
partially tighten.
g. Before final tightening check freedom of rotation by turning shaft by hand. There should be no drag or binding
h. Alternately tighten nuts (8) and adjust as necessary.
i. Check for binding and drag.
FOLLOW ON PROCEDURE
5-6