TM 9-4120-399-14
b. Test.
NOTE
Motor must be cool when tested.
(2) If continuity is not indicated, replace motor.
Installation.
c.
(1) Install motor mount (20), four lock washers (19), four flat washers (18), and four
screws (17).
(2) Attach motor shaft (16) to impeller fan (11) and place motor to unit.
(3) Install four lock nuts (15), four flat washers (14), four flat washers (13), and four
bolts (12).
(4) Center impeller fan (11) in scroll and tighten set screw (10) on impeller fan.
(5) Connect motor wiring to wiring harness and remove tags.
(6) Install stiffener bracket (9), motor mounting bracket (5), two lock washers (8), two
flat washers (7), and two screws (6).
(7) Install J1 mounting bracket (5) and two screws (4).
(8) Install three lock washers (3), three flat washers (2), and three screws (1).
4-108