TM 9-4120-402-14
4-21. FILTER (RADIO FREQUENCY) MOUNTING PLATE. - continued
a. Inspect.
Check that plate (1) is not bent, cracked, or punctured. If damaged, notify supervisor.
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel and property. Do
not use near open flame or excessive heat. Use in well ventilated area.
b. Clean.
Wipe or vacuum all dust and dirt off plate (1). Clean with a cloth dampened with a detergent solution or dry
cleaning solvent. Use a soft brush if necessary to dislodge caked on dirt. Dry thoroughly.
c. Replace.
(1)
Remove eight sets of outermost screws (2) and flat washers (3).
(2)
Slip plate (1) and electromagnetic interference filter out of frame and suppofritter.
l
(3)
Remove four sets of screws (4), lock washers (5) and flat washers (6).
(4)
Remove mounting plate (1).
(5)
Secure electromagnetic interference filter to plate (1) with four sets of screws (4), lock washers (5) and flat
washers (6).
(6) Carefully slip electromagnetic interference filter into frame and secure plate (1) to casing with eight sets of
screws (2) and flat washers (3).
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source.
4-73
