TM 9-4120-402-14
4-27. CONTROL PANEL. - continued
d. Install.
Carefully work control panel (2) into unit and tighten captive mounting screw (1).
e. Adjust.
Set controls for desired mode of operation.
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source.
4-28. WIRING HARNESS, CONTROL PANEL.
This task covers:
a. Inspect
b. Test
c. Repair
d. Replace
INITIAL SETUP
Tools
Equipment Conditions:
Refrigeration Unit Service Tool Kit
CAUTION
Use disconnect switch (NOT POWER
CABLE) to disconnect power to unit.
Damage to cable connector pins will
Heat Gun
result if cable is used.
Disconnect power at power source.
Materials/Parts
Remove control panel (para4-27).
Wire
Control Panel Wiring Harness
Lock Washers (6)
Insulation Sleeving
(Heat-Shrink Tubing)
Soldier
a. Inspect.
(1) Remove four sets of screws (1), lock washers (2), and flat washers (3) securing control panel (4) to control
box (5).
(2) Carefully pull control panel (4) away from control box (5) as far as harness (9) will allow.
4-91