TM 9-4120-402-14
5-28. SOLENOID VALVE (L1). - continued
Figure 5-18. Solenoid Valve (L1)
(3)
Remove two screws (5). Remove tube and plunger assembly (6), gasket (7), and diaphragm (8).
(4)
Check valve body (9) for visible damage. Normally valve body replacement is unnecessary. If valve
body is in good condition, skip steps (5) through (7).
(5)
Purge refrigerant system. (See paragraph 5-12.)
(6)
Debraze tube connections (10). (See paragraph 5-13.)
(7)
Remove two screws (11) and lock washers (12). Remove valve body (9).
(8)
Secure valve body to casing side with two screws (11) and lock washers (12).
(9)
Braze tube connections (10). (See paragraph 5-13.)
(10) Install diaphragm (8) into valve body (9) and gasket (7) into tube and plunger assembly (6).
(11) Secure tube and plunger assembly (6) to valve body (9) with two screws (5).
(12) Slide coil (3) and data plate (2) onto valve body stem (4). Secure with nut (1).
(13) Using wiring diagram figure 4-10 and tags, connect wire leads to solenoid coil. Remove tags.
(14) Install new refrigerant desiccant dehydrator. (See paragraph 5-21.)
NOTE
FOLLOW-ON MAINTENANCE:
Install control assembly (para 4-34).
5-70
