TM 9-4120-402-14
5-31. EVAPORATOR COIL. - continued
(15) Slide both evaporator coil brackets (12) into place.
(16) Aline and loosely install seven sets of screws (4) and packing with retainers (5) that secure coil
brackets (12) to casing sides.
(17) Aline and loosely install two sets of screws (7) and flat washers (8) that attach mist eliminator brackets
(9).
(18) Aline and loosely install remaining six sets of screws (11) and flat washers (12) in lower mounting
flange holes.
(19) Tighten all evaporator mounting hardware.
(20) Position the two side panel inserts (3) in place and secure with four screws (2).
(21) Secure distributor line clamp (16) in place with screw (13), lock washer (14), and flat washer (15).
CAUTION
Protect expansion valve during brazing operations. Direct flame away from valve body and wrap
valve body with wet rags.
(22) Braze tube joint (1) and distribution lines header at expansion valve. (See paragraph 5-13.)
(23) Install fan motor. (See paragraph 4-47.)
(24) Install heaters and support. (See paragraph 4-44.)
(25) Install coil frost switch. (See paragraph 4-33.)
(26) Install new refrigerant desiccant dehydrator. (See paragraph 5-21.)
NOTE
FOLLOW-ON MAINTENANCE:
Install mist eliminator (para 4-25).
5-78
