TM 9-4120-403-14
(12) Insert the two spacers in motor bracket and aline with holes.
(13) Install two screws, lockwashers and flat washers in motor bracket through spacers.
(14) Hand tighten the four screws, washers, and self-locking nuts in motor flange.
(15) Tighten the two screws, lockwashers and flat washers in motor bracket.
(16) Align clamps securing copper tubing to bulkhead wall with spacers and secure with screws and locknuts.
(17) Connect plug P2 to connector J2.
Follow-on procedure:
(1)
(2)
4-143