TM 9-4910-387-14-1
10 ADAPTER BRACKET (11020392) (29). Install
on mounting ring adapter assembly (25) using
four flat washers (MS27183-14) (30) and four
capscrews (MS90725-64) (31).
9
MOUNTING
RING
ADAPTER
ASSEMBLY (11020532) (25). Install
on fuel injector pump (26) using four
flat washers (MS27183-14) (27) and
four capscrews (MS90725-60) (28).
NOTE
Engage fuel injector pump fully with drive
shaft coupling, then back off leaving
approximately a 1/16-in. (0.159-cm gap.
Manually rotate adapter coupling (18) to
ensure fuel injector pump is engaged.
11. FUEL INJECTOR PUMP (26). Position on mounting
rails (32) to engage with drive shaft coupling (21).
12
CLAMP BAR (11020262) (33) AND HAND KNOB
ASSEMBLY (11020266 (34). Install into adapter
bracket (29) from under mounting rails (32).
13
HAND KNOB ASSEMBLY (34). Tighten.
2-155
