TM 9 4910-387-14-2
ADJUSTMENT
NOTE
The adjustment procedures must be performed on both
adjustment collars. Repeat the procedures for the other
adjustment collar. If adjustment is required during
operation, adjustment may be performed without
removing the clutch assembly from the tester.
1 SHIPPER SLEEVE (1). Position in neutral (center of travel).
2 RETAINING RING (2).
Lift high enough to clear teeth (3) on
adjustment collar (4).
3 ADJUSTMENT COLLAR (4). Turn counterclockwise by hand as far
as it will go, then turn clockwise one notch.
4 RETAINING RING (2).
Release so it engages teeth (3) on
adjustment collar (4).
NOTE
During operation of the tester, further adjustment of the
clutch assembly may be necessary.
Refer to
test/adjustment procedure of the drive unit assembly,
6-513