BASIC ITEMS ISSUE LIST
Section I. INTRODUCTION
3. Explanation of Columns
This appendix is a list of basic issue items. It is
composed of those items which make up the major end
a. Source, Maintenance, and Recoverability Code
item of equipment and the operator's tools and
equipment that are issued with the equipment and are
required for stockage.
(1) Materiel numerical codes (colm 1a). This
column is not required.
2. Requisitioning a Part to Which FSN Has Not
(2) Source (colm 1b). This column indicates
the selection status and source for the
listed item. Source code used in this list
When requisitioning a C source (local procurement)
item identified only by a manufacturer's part number, it
is mandatory that the following information be furnished
the supply officer:
C ....................... Obtain through local procurement. If
not obtainable from local procurement,
a. Manufacturer's code number (5-digit No.
requisition through normal supply
preceding the colon in the descriptive colm).
channels with a supporting statement
b. Manufacturer's part number (the No., and
sometimes letters, following the colon, ( (1) above).
Dashes, commas, or other marks must be included
exactly as listed.
(3) Maintenance level (colm 1c).
c. Nomenclature exactly as listed herein, including
column indicates the category of
dimensions if necessary.
maintenance authorized to install the
d. Name of manufacturer of end item (from cover
listed item. Maintenance level code used
of TM or manufacturer's nameplate).
in this list is
e. Federal stock number of end item (from TM).
f. Manufacturer's model number (from TM or
name/data plate, preferably name/data plate).
O/C ................... Operator or crew maintenance
(4) Recoverability (colm 1d). This column
g. Manufacture's serial number (from name/ data
indicates whether unserviceable items
should be returned for recovery or
h. Any other information such as type, frame
salvage. When no code is indicated, the
number, and electrical characteristics, if applicable.
item will be considered expendable.
i. If DD Form 1348 is used, fill in all blocks except
Recoverability code used in this list is
4, 5, 6, and Remarks field, in accordance with AR
72550. Complete form as follows:
R ........................ Items
repairable at direct and general
(1) In blocks 4, 5, and 6, list manufacturer's
support maintenance activities and
code and manufacturer's part number (as
normally are furnished by supply on
listed in description colm).
an exchange basis.
(2) In Remarks field, list noun name (repair
part), end item application (FSN of end
item), manufacturer, model number (end
item), serial number (end item), and any
other pertinent information such as frame
number, type, etc.