TM 9-4910-638-14&P
CAUTION IN CLAMPING
IN CLAMPING THE MACHINE TO THE BLOCK, ALWAYS USE THE SPECIAL WRENCH FURNISHED
FOR THIS PURPOSE. THE CLAMPING DEVICE INSIDE THE BASE OF THE MACHINE HAS A
POWERFUL LEVERAGE, AND ONLY A MEDIUM PULL ON THIS WRENCH IS NECESSARY TO
POSITIVELY CLAMP THE BAR. A HEAVY PULL ON THIS WRENCH WILL CLAMP THE BAR TOO
TIGHTLY AND CONSEQUENTLY DISTORT THE CYLINDER BLOCK, RESULTING IN OUT-OF-ROUND
HOLES AFTER THE MACHINE HAS BEEN UNCLAMPED. OVER CLAMPING WILL, ALSO, FORCE
THE CLAMP NUT, FORMING DEPRESSIONS IN THE T-SLOT OF THE ANCHOR CLAMP. THIS WILL
EVENTUALLY CAUSE CENTERING TROUBLE AS THE CLAMP NUT WILL SLIP INTO THE
DEPRESSIONS WHILE CLAMPING, MOVING THE MACHINE OFF CENTER AS FORCE IS APPLIED TO
THE CLAMP.
ANCHORING DEVICE
Furnished with the anchoring device are different lengths of clamps, entering screws and anchor bolts.
The
capacities of these different parts are as follows:
ANCHOR CLAMP ASSEMBLIES
055-0462-20
Anchor Clamp Assembly
#2
Capacity
3-1/4" to 3-7/8" Diam.
055-0463-28
Anchor Clamp Assembly
#3
Capacity
3-7/8" to 4-1/2" Diam.
055-0464-25
Anchor Clamp Assembly
#4
Capacity
4-1/2" to 5-1/4" Diam.
055-0465-25
Anchor Clamp Assembly
#5
Capacity
5-1/4" to 6" Diam.
055-0466-22
Anchor Clamp Assembly
#6
Capacity
6" to 6-3/4" Diam.
CENTERING SCREWS
062-0456-04
Centering Screw - Short
Capacity
Up to 4" Diam.
062-0457-01
Centering Screw - Medium
Capacity
4" to 5-1/2" Diam.
053-0458-47
Centering Screw - Long
Capacity
5-1/2" to 7" Diam.
EXTENSION RODS
055-0472-43
Short Extension Rod
6-5/8" Long
Capacity
6-1/2" to 10"
055-0473-40
Medium Extension Rod
8-5/8" Long
Capacity
8-1/2" to 12"
053-0474-40
Long Extension Rod
10-5/8" Long
Capacity
10-1/2" to 14"
-6-