TM 9-2330-381-14
4-26.
STOP LIGHT/TAIL LIGHT (CONT)
2.
Install gasket (7), light lens (6), and retaining ring (5) into stop light/tail light (4).
3.
Aline and install stop light/tail light (4) to platform. Secure in place with three screws (3), clamp (2.1), and three
locknuts (2).
4.
Reconnect stop light/tail light socket connector (1) to W2 harness.
FOLLOW-ON MAINTENANCE
Reconnect intervehicular electrical cable and check stop light/tail light for proper operation (para. 2-24).
4-27.
CLEARANCE LIGHT
This task covers:
a. Disassembly
b. Inspection
c.
Assembly
INITIAL SETUP
Tools
General mechanics tool kit, item 16, appx. B
Materials/Parts
Preformed felt
Locknut (4)
Lockwasher
Lockwasher
Equipment Condition
Semitrailer parked on level ground, parking brakes applied, and intervehicular cables disconnected (para. 2-24)
NOTE
The following procedure is to be used for all clearance lights located on either the
curbside or streetside of platform. To repair or replace all clearance lights, repeat
this procedure as necessary.
DISASSEMBLY
1.
Tag and disconnect clearance light socket connector (1) from platform wiring harness.
4-110 Change 1