TM 9-2330-381-14
NOTE
The suspension, when in its normally installed position, mounts the smaller end of
the shouldered shaft toward the right-hand side of the suspension assembly.
Thus, the shouldered shaft must be driven out starting from the right-hand side
driving toward the left-hand side.
10.
Using a hammer and brass drift, drive shouldered shaft (21) from left-hand side of lower suspension arm (17) and
remove from upper and lower suspension arms (5 and 17).
11.
Using two people to maneuver overhead lifting device and upper suspension arm (5) and one person
holding/supporting lower suspension arm (17), separate lower suspension arm (17) from upper suspension arm
(5) by pulling overhead lifting device away from lower suspension arm (17).
DISASSEMBLY
1.
Remove lubrication fitting (22) from upper suspension arm (5).
2.
Using a hammer and brass drift, drive lower bearing cone (23) and nonmetallic seal (24) out of bottom side of
upper suspension arm (5). Discard seal.
4-195