TM 9-2330-381-14
4-79.
SUSPENSION CONTROL MANIFOLD (CONT)
3.
Remove clamp block and handle of suspension shut-off valve from hydraulic control module (para. 4-84).
4.
Using a drain pan, tag and disconnect four hydraulic tubes (5, 6, 7, and 8) from four straight pipe-to-tube adapters
(9) on suspension control manifold (10) and 4-way directional control valve bank (11). Install caps/plugs into tube
openings.
5.
Tag and disconnect five hydraulic tubes (12, 13, 14, 15, and 16) from five straight pipe-to-tube adapters (9) on
suspension control manifold (10) and suspension shut-off valve (17). Install caps/plugs into tube openings.
6.
Tag and disconnect hydraulic tube (18) from straight pipe-to-tube adapter (9) on suspension control manifold (10)
and bulkhead fitting at back of control module (4). Install caps/plugs into tube.
7.
Tag and disconnect four hydraulic tubes (19, 20, 21, and 22) from four straight pipe-to-tube adapters (9) on
suspension control manifold (10) and 4-way directional control valve bank (11). Install caps/plugs into tube
openings.
8.
Using two wrenches, tag and disconnect three hydraulic tubes (23, 24, and 25) from three straight pipe-to-tube
adapters (9) on suspension control manifold and fittings on three pressure gages (26). Install caps/plugs into
tubes and onto gage fittings.
9.
Using one person, support suspension control manifold (10); using a second person, remove three capscrews
(27), lockwashers (28), and suspension control manifold (10) from hydraulic control module frame (4). Set
suspension control manifold (10) on platform. Discard lockwashers.
10.
Remove three tube fitting plugs (29) and three preformed packings (30). Discard preformed packings and install
caps/plugs into openings.
11.
Remove 17 straight pipe-to-tube adapters (9) and preformed packings (30) from suspension control manifold (10).
Discard preformed packings and install caps/plugs into manifold openings and onto fittings.
4-388