TM 9-2330-381-14
4-79.
SUSPENSION CONTROL MANIFOLD (CONT)
4.
Using one person, aline and support suspension control manifold (10) with hydraulic control module frame (4).
5.
With first person holding suspension control manifold (10), use a second person to install three capscrews (27)
6.
Remove caps/plugs installed into three hydraulic tubes (25, 24, and 23). Using two wrenches, install three
hydraulic tubes (25, 24, and 23) between three straight pipe-to-tube adapters (9) on suspension control manifold
(10) and fittings on three pressure gages (26).
7.
Remove caps/plugs installed into four hydraulic tubes (22, 21, 20, and 19). Install four hydraulic tubes (22, 21,
20, and 19) between four straight pipe-to-tube adapters (9) on suspension control manifold (10) and fittings on
4-way directional control valve bank (11).
8.
Remove caps/plugs installed into hydraulic tube (18). Install hydraulic tube (18) between straight pipe-to-tube
adapter (9) on suspension control manifold (10) and bulkhead fitting on back of hydraulic control module (4).
9.
Remove caps/plugs installed into five hydraulic tubes (16, 15, 14, 13, and 12). Install four hydraulic tubes (16, 15,
14, 13, and 12) between five straight pipe-to-tube adapters (9) on suspension control manifold (10) and fittings on
suspension shut-off valve (17).
10.
Remove caps/plugs installed into four hydraulic tubes (8, 7, 6, and 5). Install four hydraulic tubes (8, 7, 6, and 5)
between four straight pipe-to-tube adapters (9) on suspension control manifold (10) and fittings on 4-way
directional control valve bank (11).
11.
Aline and install handle of suspension shut-off valve and clamp block back into place on hydraulic control module
12.
Using two people, aline and install lower panel (3), with door panel attached, onto hydraulic control module (4).
Secure lower panel in place by installing six lockwashers (2) and capscrews (1).
4-394