TM 9-2320-366-10-2
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e. ELECTRICAL SYSTEM (CONT)
REAR HAZARD LIGHTS DO NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-27c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB71) in PDP to see if it is tripped.
(a)
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
(h)
If rear hazard lights still do not illuminate, notify Unit Maintenance.
FRONT AND REAR HAZARD LIGHTS DO
NOT ILLUMINATE.
Step 1. Check operation of front and rear turn signals (para 2-27c).
(a)
If front and rear turn signals do not illuminate, perform Electrical System Troubleshooting (e56.
Front and Rear Turn Signals Do Not Illuminate).
(b)
If left or right front turn signal does not illuminate, perform Electrical System Troubleshooting
(e57. Left or Right Front Turn Signal Does Not Illuminate).
(c)
If turn signals illuminate, go to Step 2 of this fault.
Step 2. Check circuit breaker (CB71) in PDP to see if it is tripped.
(a)
Position main light switch to OFF (para 2-27c).
(b)
(c)
Check circuit breaker (CB71) to see if it is tripped.
(d)
If circuit breaker (CB71) is tripped, push in to reset.
(e)
(f)
Position main light switch to SER DRIVE (para 2-27c).
(g)
Position hazard lights switch to on (para 2-27c).
(h)
If front and rear hazard lights still do not illuminate, notify Unit Maintenance.
Change 1