TM 9-2330-227-14&P
Section VIII. SPRING M A I N T E N A N C E
Page
Page
Radius Rods . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-73
U-Bolts, Radius Rod Bracket,
Spring Brackets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-68
and Spring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-63
U-BOLTS, RADIUS ROD AND BRACKET, AND SPRING
This task covers:
INITIAL SETUP
Tools Continued
Tools
Punch, drive-pin, 13/4-inch
Blocks, wood
Screwdriver, flat-tip, 3/16-inch
Driftpin, steel with brass tip,
1/2-inch
Socket, 1/2-inch drive, 5/8-inch
Socket, 1/2-inch drive, 15/16-inch
Extension, 1/2-inch drive, 4-inch
Extension, 3/4-inch drive, 6-inch
Socket, 3/4-inch drive, 17/16-inch
Trestle, motor vehicle, 8-ton (two required)
Hammer, ball-peen, machinist's, 2-lb
Wrench, open-end, 15/16-inch
Personnel Required
Jack, hydraulic, 10-ton capacity
(two required)
Pliers, slip-joint, straight-nose
Two
Punch, drive-pin, 1-inch
Equipment Condition
Brake backing plate removed from axle on
ACTION
LOCATION
ITEM
REMARKS
NOTE
Both springs and attaching parts are removed and installed the same way. This task is
for one; repeat for the other.
5-63