TM 9-2330-356-14
accessible. Remove lock ring (28) and drive assembly (29)
from armature (27). Do not disassemble drive assembly.
(11), and remove backplate assembly (12) and thrust
washers (21). Remove nuts and washers (13) from brush
Cleaning and Inspection.
b.
assembly (15). Raise brush spring (14), and lift brushes (15)
(17), and remove brush holder (18). Raise springs (14) and
WARNING
lift other brushes from brush holder. Remove springs (14)
from brush holder.
Dry cleaning solvent P-D-680 Is toxic and
Always wear protective
flammable.
(4) Remove retainer (23), boot (24), and pin (25).
goggles and gloves, and use only in a
Separate pinion housing (22) and frame assembly (19). Do
well-ventilated area. Avoid contact with
not lose thrust washer (21). Remove other set of brushes
skin, eyes, and clothes, and DO NOT
(20) by cutting leads l-inch on each side of welded
breathe vapors. DO NOT use near open
flame or excessive heat. The solvent's
flash point is 100F-138F (38C-59C).
If you become dizzy while using cleaning
(5) Remove yoke (26), and remove armature (27)
solvent, immediately get fresh air and
and drive assembly (29). Remove lock ring and stop (28) by
medical help. If solvent contacts eyes,
pressing stop toward armature until lock ring becomes
7-56