TM 9-2330-356-14
(3) Cleaning and Inspection.
(a) Screw seat (12) into body (21),
WARNING
(b) Install O-ring (19) onto bearing retainer
(18). Install O-ring (20) into bearing retainer.
Dry cleaning solvent P-D-680 is toxic and
(c) Install washer (17), O-ring (16), O-ring
flammable. Always wear protective goggles
(15), and retainer (14) onto stem (11). Retain these parts
and gloves, and use only in a well-ventilated
with nut (13).
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO
(d) Install the assembled stem through
NOT use near open flame or excessive heat.
bottom of body (21). Install washer (9), O-ring (10),
The solvent's flash point is 100F-138F
diaphragm (7), washer (8), and nut (6).
(38C-59C). If you become dizzy while
(e) Install spring (5) into body (21). Screw
using cleaning solvent, Immediately get fresh
cover (3) with O-ring (4) into body.
air and medical help. If solvent contacts eyes,
immediately wash your eyes with water and
(f) Install cover (2) and secure with eight
get medical aid.
screws (1).
(5) Installation.
(a) Clean all metal parts in dry cleaning
(a) Screw diaphragm valve onto nipple at
the separator valve.
(b) Inspect all parts for damage. If parts
(b) Connect the two lines to the diaphragm
other than O-rings and the diaphragm need replacement,
valve.
replace entire valve.
TA113226
8-28