TM 9-2330-394-13&P
BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR - Continued
0056 00
INSTALLATION - Continued
NOTE
One anchor (solid) and one adjusting plunger must be installed in each plunger housing.
Install anchor plunger marked "L" in left plunger housing. Install anchor plunger marked
"R" in right plunger housing.
4.
Apply film of grease on anchor plunger (7).
5.
Install and seat seal (6) and anchor plunger (7) in plunger housing (5).
6.
Position lockwasher (4) and guide screw (3) in plunger housing (5).
Tighten guide screw (3) to 15-25 lb-ft (20-34 Nm).
7.
0056 00-9