TM 9-4120-388-14
4-9. ALTERNATE lNPUT POWER CABLE CONNECTOR (J1) LOCATIONS - continued.
NOTE
Take care that the protective electrical connector cover that was removed at the rear pan-
el is reinstalled at the new location.
Install gasket and cover plates over connector hole patterns at bulkhead and rear panel.
j.
k. Coil loose excess harness so that it will not be damaged.
Install conditioner air intake grille. (See para 4-24.)
l.
n.
4-10. INSTALLATIONS THAT REQUIRE REMOVAL OF
FABRIC COVER. Some installations require removal of
the
condenser side fabric cover. This generally applies only when the air conditioner is positioned inside with condenser and
fresh air openings ducted to the outside.
NOTE
If air conditioner is to be installed with condenser side (rear) exposed, the fabric cover
should be left in place if possible.
a Remove fourteen screws, four packing with retainer, and eighteen flat washers.
b. Carefully remove the fabric cover. Store the cover in a safe place for future use.
4-11. INSTALLATION INSTRUCTIONS. All alterations to
the shelter or
facility into which the air conditioner is to be
installed should be complete before installation of air conditioner.
DO NOT LIFT without holding unit in upright position. Unit will fall over.
Attach an overhead hoist through a sling and spreader bar to the lifting handles on each side of the cabinet.
a.
b. Move air conditioner into position and align mounting holes.
c.
Secure unit with appropriate mounting hardware.
Base -.4375-14 UNC (4 holes)
Rear -.3125-24 UNF (3 holes)