Refer to TM 9-2330-202-14&P and disconnect trailer from towing vehicle.
Serious injury to personnel can result if the trailer up-ends when disconnected
from the towing vehicle. Trailer leg prop assembly must be down before operating
Pull out pin (1) that secured leg prop assembly (2) in traveling position. Refer to figure 4-4.
f. Pull leg prop assembly (1) down.
Insert pin (2) in bracket (3) to secure leg prop assembly (1) in operating
Turn leg base (4) until it makes firm contact with ground.
Refer to MIL-HDBK-116, Environmental Control of Small Shelters for
4-10. PREPARATION FOR INSTALLATION.
4-11. INSTALLATION INSTRUCTIONS. All alterations
to the shelter
or facility into which the trailer-mounted, generator-
set powered, air conditioner with power is to be installed should be complete before installation of air conditioner.
Position trailer so that air conditioner duct adapters can be easily attached to the shelter. (Refer to paragraph
Secure flexible ducts to shelter using mounting hardware. (Ref er to paragraph 4-13).
Seal all openings around flexible ducts; air and watertight. Use gasket, caulking,
Install auxiliary fuel hose to be used and fuel drum adapter. (Refer to paragraph 4-15).
Secure shelter adapter onto shelter. Refer to figure 4-5.
Take care not to damage the rubber molded gasket on shelter adapter during
Refer to air conditioner electrical schematic, TM 5-4120-384-14, for additional wiring information.