TM 9-4910-387-14-2
NOTE
Shouldered
shaft
part
locations should be marked
and
measured
for
reassembly.
A press may be necessary to
install bushings, flywheel,
shaft pillow blocks, and
sprocket.
25 KEY (29) AND BUSHING (27).
Install in shouldered shaft (23).
27 FLYWHEEL (26), THREE LOCK WASHERS (25), AND THREE
SCREWS (24). Install on bushing (27).
26 SETSCREW (28). Tighten.
NOTE
Some tester models have pins to secure
shaft pillow blocks to tester frame. Aline
holes in shaft pillow blocks and tester
frame, then drive pins in.
29 SHOULDERED SHAFT (23) WITH
ATTACHED PARTS. Position on tester
and locate shaft pillow blocks on tester
frame.
30 FOUR FLAT WASHERS (21), FOUR
SCREWS (19). Install.
31 KEY (18) AND BUSHING (17). Install
on shouldered shaft (23).
28 TWO SHAFT PILLOW BLOCKS (22).
32 SETSCREW (16). Tighten.
Install on shouldered shaft (23).
6-181