TN 3-1040-262-13&P
Figure 4-5. Gun, exploded view.
(5) Secure the inlet body (23) with a pair of
(11) Remove the old teflon packings (25) and
pliers and remove the nozzle housing and tubing
the flat washer (24) from the inlet body (23).
assembly (18), and aluminum gasket (19), and the
c. Gun Reassembly.
hexagon plain nut (33).
(1) Insert the flat washer (24) and new teflon
(6) Inspect the preformed packings (20) and
packings (25) in the inlet body (23).
replace if damaged.
(2) Insert the stem (22) into the inlet body (23)
(7) Unscrew the stem (22) from the trigger
and through the teflon packings (25).
guide (30).
(3) Screw the packing screw (26) into the inlet
(8) Remove the inlet body (23) and stem (22)
body (23) and tighten it wrench tight.
as one piece.
(4) Hold the hexagon plain nut (33) between
(9) Remove the flat washers (27 and 29),
the trigger (34) and the hole in the handle body assembly
helical compression spring (28), and the hexagon plain
(31). Place the flat washer (29) on the trigger guide (30).
nut (33).
Place the helical compression spring (28) over the trigger
(10) Remove the packing screw (26). Pull the
guide (30). Place the flat washer (27) on the stem (22).
stem (22) out of the inlet body (23).
4-11
