TM 3-1040-262-13&P
(1) Slide an air cylinder (10, Fig 1-4) into
NOTE
position on the frame assembly.
(2) Fasten the spring loaded clamp (6, Fig 1-
The coupler assembly cannot be
2) to
secure the air cylinder to
the frame and harness
removed from the air cylinder unless
assembly.
the grip knob is closed.
(3) Connect the valve actuating coupler
a. Removal
assembly (13, Fig 1-4) to the nipple assembly (14).
4-24. Nonmetallic Hose Assembly and Preformed
(2) Unfasten the coupler assembly (13) from
Packing
the nipple assembly (14).
Organizational maintenance personnel are authorized to
(3) Unscrew the nonmetallic hose assembly
replace the nonmetallic hose assembly (low pressure)
(2) from the tube to boss straight adapter (3).
and preformed packing.
(4) Unscrew the hose assembly (2) from the
a. Removal
coupler assembly (13).
(1) Disconnect the female quick-disconnect
(5) Replace damaged coupler assembly or
coupling half (8, Fig 1-4) from the male quick-disconnect
faulty hose.
coupling half (7).
b. Installation. Installation procedure is the reverse
(2) Unscrew the nonmetallic hose assembly
of removal procedure.
4-23. Air Cylinder
(3) Inspect the preformed packing (2).
Organizational maintenance personnel are authorized to
Replace, if damaged.
replace the air cylinder.
b. Installation. Installation procedure for the hose
a. Removal Remove the air cylinder from the frame
assembly is the reverse of the rermoval procedure.
b. Installation.
4-13