TM 5-1940-322-10
0011 00
BEB RETRIEVAL USING CBT (Contd)
RETRIEVE BOAT (Contd)
9.
Transporter operator, place PTO ENGAGE switch (7) in ON position.
10.
Transporter operator, place MODE SELECTION switch (9) in AUTO position.
11.
Transporter operator, place HIGH IDLE switch (6) in ON position.
12.
Ground guide signals transporter operator to place and hold joystick (8) in
UNLOAD position, until cradle is in place.
13. Boat crew members will lower mast (WP 0004 00).
1
2
3
NOTE
Once BEB is aligned to center of stanchions, idle engines down
to 1,100 RPM to maneuver into cradle.
14. Boat operator will back boat into position on cradle (WP 0028 00).
15. Boat crewmembers will fasten load binder cables (1) to boat aft lifting eyes (2).
CAUTION
Engines must not be running during retrieval. Failure to
comply may cause damage to equipment.
Ensure scoop reverse deflectors are in full up position prior to
boat retrieval or damage to deflectors may result.
16.
Boat operator will put scoop reverse deflector control levers in full up position,
refer to WP 0004 00, and stop engines. Refer to WP0013 00.
17.
Ground guide signals operator to place and hold joystick (8) in LOAD position
until cradle (3) is fully loaded on transporter (5).
18.
Transporter operator, place HIGH IDLE switch (6) in OFF position.
19.
Transporter operator, place PTO ENGAGE switch (7) in OFF position.
20.
Transporter operator, place transmission in D (drive) position.
21.
Transporter operator, release parking brake (4).
0011 00-6
