c. Headlight Installation.
Procedure to install headlights is the same for all locations. Right-side bucket position shown.
Position headlight assembly (7) on light mount (6).
Rotate T-bar (5) approximately 90 degrees, so that it will not fit between retaining bars on light mount (6).
Tighten knob (4) to secure T-bar (5) against retaining bars on light mount (6).
Perform Step (4) for 4-in-1 bucket positions only.
Route cable (2) through eye loop (3).
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts battery terminal, a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
Connect light plug (1).