TM 55-4920-390-13&P
5-10. REPLACEMENT OF DIODE PACKAGE . (See Fig. 1-3). To replace the "Diode Package", Part #B2726, proceed
as follows -
a) Open hand-held lamp and remove reflector as in 5-9, a thru e.
b) Unsolder wires from "terminal strip" on diode package. Mark wires to facilitate replacement.
c) Loosen acorn nut at small end of housing (nearest terminal strip end of diode package), but do not remove it.
d) Remove the other acorn nut and screw. Do not unwire solder lug.
e) Remove old diode package.
f) Replace diode package by sliding it under screw head which is hanging loose from its acorn nut. (5-10, c).
g) Replace other screw and acorn nut, making sure solder lug with its two wires is secured under screw head and
that lockwasher is under acorn nut on outside of housing.
h) Tighten acorn nuts, rewire, replace reflector and restore.
5-7/(5-8 blank)
