TM 9-2320 -209-10-1
a.
Before Engine Startup.
FRAME 1
Pull handbrake lever (1) up to position.
1.
NOTE
The handbrake must click into place when handbrake lever (1)
is being pulled up. If you do not hear a click adjust handbrake
as given in steps 2 through 5.
2.
Push handbrake lever (1) forward to off position.
If the handbrake is loose (not enough tension) turn knob (2) to the right one or two
3.
turns. If the handbrake is tight (too much tension) turn knob (2) to the left one or
two turns.
4.
Pull handbrake lever (1) up again.
If handbrake clicks into place it is properly adjusted. If click is not heard, do
5.
steps 2, 3 and 4 again until handbrake clicks into place.
6.
If handbrake cannot be properly adjusted tell organizational maintenance.
7.
Set FRONT TRANSMISSION gearshift lever (3) to N position.
GO TO FRAME 2
