TM 9-2320-209-10-1
FRAME 6
WARNING
Do not pull winch control lever (1) back while a load is still
hanging on cable. Taking winch control lever out of forward
position will cause load to drop.
1.
If there is a load attached to end of winch cable (2) do the following steps:
(a) Press clutch pedal (3) all of the way in.
(b) Place the power divider control lever (4) in the REAR WINCH REV position.
(c) Lower the load and unhook cable (2) from the load. Refer to frames 5 and 6.
2.
Lower derrick tube (5) if it was raised. (Refer to para 4-15c.)
Remove winch cable (2) from sheaves (6) that were used. (Refer to para 4-15j.)
3.
Press clutch pedal (3) all of the way in.
4.
Place power divider control lever (4) in REAR WINCH FWD position.
5.
Let clutch pedal (3) up and wind in cable (2).
6.
Press clutch pedal (3) all of the way in.
7.
Place rear winch control lever (1) in NEUTRAL position and set locking latch (7).
8.
GO TO FRAME 7
4-327