TM 9-2320-211-10-1
FRAME 4
To stop the power plant heater, set the HILO switch (1) to LO position.
1.
Set START-OFF-RUN switch (2) to OFF position. Burner will stop within
2.
a few seconds.
Indicator light (3) will remain on. Blower will keep running until burner
3.
cools and unburned gases are out.
NOTE
Always wait until indicator light (3) goes out before trying
to restart power plant heater.
4.
If heater fails to start after three tries or stops after a short run, tell direct
support maintenance.
4-219
