TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
NOTE
If retrieval system was lowered to assist in power
plant removal, raise retrieval system to stowed
position.
Chains may be attached to shackles on rear of
wrecker and power plant to prevent power plant
from swinging.
(11) Operate TELESCOPE control lever (7) and HOIST control lever (3) to
position power plant (1) approximately 3 ft (1 m) behind crosstube (8)
and 2 ft (60 cm) above ground.
(12) Shut off REMOTE CONTROL UNIT switch (9).
(13) Stow REMOTE CONTROL UNIT on vehicle.
CAUTION
Drive wrecker forward at walking speed (less than
5 mph). If driven faster and power plant starts to
swing, equipment can be damaged.
(14) Transport power plant to required destination.
2-649
