TM 9-2320-366-10-2
CAUTION
Ensure there are no gaps between layers of cable. Gaps between cable
layers indicate loose winding. Failure to comply may result in damage to
equipment.
NOTE
Perform steps (22) through (25) if cable is not winding properly.
(22) Position MAIN WINCH RH switch (11) to OUT.
(23) Pay out cable (12) until cable on 30K winch drum has clean wind.
NOTE
Do not dead-end cable into rear rollers. Failure to comply may result in
damage to equipment.
(24) Position MAIN WINCH RH SPEED switch (10) to LOW.
(25) Continue steps (20) through (24) until cable (12) is fully recovered.
2-465
