TM 9-2320-366-10-2
LUBRICATION ORDER AND SERVICES
Section I. INTRODUCTION
F-1. GENERAL
This appendix gives lubrication services requirements for the vehicle which are the
responsibility of the Operator/Crew.
a. Adherence. Intervals (on-condition or hard time) and the related man-hour times are
based on normal operation. The man-hour time specified is the time needed to do all
the services prescribed for a particular interval. On-condition (OC) oil sample intervals
shall be applied unless changed by the Army Oil Analysis Program (AOAP)
laboratory. Change the hard time interval if lubricants are contaminated or if operating
the equipment under adverse operating conditions, including longer-than-usual
operating hours. The calendar interval may be extended during periods of low activity.
If extended, adequate preservation precautions must be taken. Hard time intervals
will be applied in the event AOAP laboratory support is not available. Hard time
intervals must be applied during the warranty period.
Intervals shown in this Lubrication Order and Services are based on mileage/calendar
times. The lubrication/services for the vehicle is to be performed at whichever interval
occurs first.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear
protective goggles and gloves; use only in well-ventilated area;
avoid contact with skin, eyes, and clothes, and do not breath
vapors. Keep away from heat or flame. Never smoke when using
Dry Cleaning Solvent; the flashpoint for Type I Dry Cleaning Solvent
is 100 F (38 C) and for Type II is 138 F (50 C). Failure to comply
may result in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent,
immediately get fresh air and medical help. If Dry Cleaning Solvent
contacts skin or clothes, flush with cold water. If Dry Cleaning
Solvent contacts eyes, immediately flush eyes with water and get
medical attention. Failure to comply may result in serious injury or
death to personnel.
b. Cleaning Fittings Before Lubrication. Clean parts with Dry Cleaning Solvent (SD
P-D-680) or equivalent. Dry before lubricating. Dashed arrows indicate lubrication on
both sides of the equipment.
Change 2
