TM 9-2330-203-14&P
Section II.
OPERATOR/CREW TROUBLESHOOTING PROCEDURES
Page
Paragraph Title
Number
Explanation of Columns .................................................................................................................
General .............................................................................................................................................
Operator/Crew Troubleshooting, Table 3-1 .......................................................................................
Troubleshooting Symptom Index .......................................................................................................
3-4. GENERAL.
a. This section provides information for identifying and correcting malfunctions that may develop while operating
your dolly.
b. The Troubleshooting Symptom Index in paragraph 3-6 lists common malfunctions that may occur and refers
you to the proper in page in Table 3-1 for a troubleshooting procedure.
c. If you are unsure of the location of an item mentioned in troubleshooting, refer to paragraph 1-7 or the
maintenance task where the item is replaced.
d. Before performing troubleshooting, read and follow all safety instructions found in the Warning Summary at the
front of this manual.
e. When troubleshooting a malfunction:
(1) Locate the symptom or symptoms in paragraph 3-6 that best describe the malfunction.
(2) Turn to the page in Table 3-1 where the troubleshooting procedures for the malfunction in question are
described. Headings at the top of the page show how each troubleshooting procedure is organized: MALFUNCTION,
TEST OR INSPECTION (in step number order), and CORRECTIVE ACTION.
(3) Perform each step in the order listed until the malfunction is corrected. DO NOT perform any
maintenance task unless the troubleshooting procedure tells you to do so.
f. This manual cannot list all malfunctions that may occur or all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-5. EXPLANATION OF COLUMNS.
The columns in Table 3-1 are defined as follows:
(1)
MALFUNCTION. A visual or operational indication that something is wrong with the dolly.
(2)
TEST OR INSPECTION. A procedure to isolate the problem in a component or system.
(3)
CORRECTIVE ACTION. A procedure to correct the problem.
3-6
